Recommended Product Combination for Mono Pitch Skillion Roof

G2500N

Over Fascia Vent

The VENT Over Fascia Vent – G2500N is the most practical and cost efficient method of ventilating the Eaves. It is easy to install, discrete and is compatible with either timber of metal fascias.

 

  • Releases hot air from roof voids and manages condensation
  • Easy to install
  • Not visible as hidden by spouting/gutter
  • The only solution to ventilate builds with no eaves
  • Forms part of a passive ventilation system that works year round with no moving parts or energy consumption

G1275

Eaves Comb Filler

The G1275 VENT Eaves Comb Filler is designed with flexible fingers that adjust to fill the gaps left when using profiled tiles or steel roof cladding, preventing entry of birds and large insects.

The use of the G1275 eliminates the need to make or buy expensive purpose made profiled fillers that can block necessary airflow into the roof spacing between underlay and roof cladding.

VB20

Ventilation & Drainage Batten

The VENT Roof cavity batten – VB20 is a 20mm Polypropylene Ventilation and Drainage Batten deigned to facilitate 16000mm² p/lm of passive airflow and cavity between the roofing underlay and roof Purlins.

The VENT VB20 reduces the risk of moisture build up and condensation in tight roof cavities.

VB10

Ventilation & Drainage Batten

The VENT VB10 is a 10mm Polypropylene Ventilation and Drainage Batten deigned to facilitate 8000mm² p/lm of passive airflow and cavity drainage between the roofing underlay or membrane and the roof cladding.

The VENT VB10 prevents the transfer of dew point from the underside of the roof cladding to the underside of the roofing underlay or membrane

RV10-Half

Ridge Vent

The VENT Ridge Vent is designed to release warm air from the roof void using the natural convection of rising warm air or by means of negative pressure created by wind blowing over the roof.

The RV10-half has an adhesive and flexible aluminium flashing which is designed to form to roofing profiles and prevent water ingress on any pitch roof.

Recommended Application :
– RV10P for cladding profiles with a through depth < 34mm
– RV10DT for cladding profiles with a through depth 34mm – 38mm

  • Allows warm moist air to escape the roof cavity
  • Forms part of a passive ventilation system
  • Works year round with no moving parts or energy consumption.

Installation Tutorials